u/vaporsteve

on 9/24 i had 28 teeth extracted due to a combination of health issues causing a lot of my teeth to rot out. I'm gonna be honest here, we are a single income family and have a very limited food budget, and we can not afford to buy 2 different sets of groceries to accommodate 2 different sets of dietary needs. for the foreseeable future (at least the next month or so) i am restricted to a soft foods only diet. my partner and my son still have to eat regular food, and i don't expect them to survive on mashed potatoes like i have been doing for the last 10 days, so im just looking for some variety so i don't have to keep surviving on just instant mashed potatoes and mac and cheese. Thank you

https://www.amazon.com/hz/wishlist/ls/104PLKFERJ4RV?ref_=wl_share

So, i ran into an issue where the right nozzle filament cutter stopper was being pushed off the 90 degree and was slipping off the filament cutter. i followed the Bambu wiki about this issue found here https://wiki.bambulab.com/en/h2/troubleshooting/cutter-stopper-tooth-jumping-repair-guide

installed the stopper and the issue continued. after 3 or 4 tries re-doing the alignment. only after taking the left side cutter off to compare did i see where i was having an issue. where the pivoting nub attaches to the housing there is a little white plastic ball that sits on top of a spring under the pivot assembly. this ball had somehow come out of the hole and was sitting off to the side preventing the nub from locking into place during the movement.

https://preview.redd.it/vuhkbgtfh6mh1.png?width=498&format=png&auto=webp&s=358423bb08e5e87bd69c65abb29299c6af8e5b53

im posting this here in case someone else down the road comes across this issue because the wiki doesn't say anything about removing the pivot assembly and checking on that ball/spring assembly once i re seated the spring on the other cutter stopper the problem was solved. hopefully this helps someone down the road.