u/wivian692

Using the wind valley kit front panel exhaust mode, the hot air discharged from the tail of the graphics card is discharged through the 12015 fan on the front panel. At the same time, the side of the motherboard is equipped with two 6025 fans to suck out the hot air discharged down by the CPU. The motherboard area does not accumulate heat. A 12025 fan is used above the motherboard to discharge the CPU and The hot air of the gpu, the psu enters the air from above, and the front panel exhausts the air. The Fenggu kit realizes the complete isolation of the three heat sources of cpu and gpu and psu. The inlet and outwind do not interfere with each other, and the heat inside of the chassis is no longer accumulated. The use of non-public graphics cards can make the most of the CPU slot. The 50 series official graphics card does not support reverse installation. It is best to isolate 0.5 slots so that the hot wind can pass from the fan above. Profit discharge, please chat privately for details.

FormD T1 2.1 wind valley kit 4080fe build

FormD T1 Ver 2.1 wind vally kit

FormD T1 风谷套件装机