u/xScratchzz

Hi, I'm finally posting my question on this sub because It's getting so frustrating.
I bought a used Sophos SG115 Rev. 3 and wanted to install Sophos XG Home on it. Got the latest version of the ISO from their website and flashed it onto a usb-drive. Ran into issues and found out that you should format the disk using an ubuntu setup (or whatever OS).

After installing Ubuntu and trying again it finally seemed to install it, but while booting it froze. Another reddit post said that it was because of UEFI. Changed it but now it says that my "linuxbit is missing or corrupted" and I cant install at all. Changed a few settings in BIOS, installed Ubuntu again for formattig but still same issue.

I also tried the hardware version of the ISO but didnt work.

Does anyone have an idea?

Used hardware:

- Sophos SG115 Rev 3
- USB 3.1 32GB flash drive
- USB 2.0 16GB flash drive (as secondary test device)

Hi, I know this is kind of a specific question.

I've got an old Buffalo TeraStation TS5400D and I want to set up a Cloud Service with an S3 Cloud.
So I have created the bucket with the Access Key ID etc.

I just cant get it to work, because I get the same error message over and over again. Am I missing a setting that could be crucial?

The only instruction I found is this really old video (https://www.youtube.com/watch?v=VlCChSz\\\_0Wc) explaining the steps.

The steps itself are not the problem because I repeat them 1:1. I just get an error message saying "this setting is not available" after trying to create the shared folder.

does someone know if I missed something while setting up the S3 bucket?

Hi, I know this is kind of a specific question.

I've got an old Buffalo TeraStation TS5400D and I want to set up a Cloud Service with an S3 Cloud.
So I have created the bucket with the Access Key ID etc.

I just cant get it to work, because I get the same error message over and over again. Am I missing a setting that could be crucial?

The only instruction I found is this really old video (https://www.youtube.com/watch?v=VlCChSz\_0Wc) explaining the steps.

The steps itself are not the problem because I repeat them 1:1. I just get an error message saying "this setting is not available" after trying to create the shared folder.

does someone know if I missed something while setting up the S3 bucket?

Hallo zusammen,
ich habe seit ein paar Monaten den Bambulab A1 Mini und ich bin ehrlich: Es juckt in den Fingern nach einem größeren Druckbett, ABS-Druck, Mehrfarbigem Druck etc.
Ich bin aber ehrlich, ich brauche eigentlich keinen so teuren Drucker, weil ich eh 90% PLA drucke :D
Einen P2S zu kaufen macht in meinen Augen keinen Sinn, weil die extra 100€ sind dann eh schon egal. Reicht in meinem Fall evtl. schon der A1 mit AMS oder ist der Sprung auf den X2D rentabel?