r/Artillery3D

Hi all! I’m new to 3D printing and I have an Artillery X1 that I got from marketplace for really cheap. I changed the whole hotend and nozzle, so there shouldn’t be any clogging issues. It seems the first few layers print just fine, but then when more layers are tacked on it gets stringy as seen in the photos. Any help would much be appreciated!! Thank you!!

I’m using PrusaSlicer, Artillery x1 modified config with a .4mm nozzle and 1.75mm PLA+. Here are the more important settings (feel free to ask any other settings):

Layers and perimeter
Layer Height: 0.2mm
First Layer height: .24mm
Perimeters: 3 minimum
Horizontal shells
Solid Layers: 5 Top, 4 Bottom
Minimum shell thickness: 0 top, 1.2 bottom

Infill
Infill pattern: 15%
Fill pattern: Gyroid

Speed
Perimeters: 50mm/s
Small Perimeters 25mm/s
External Perimeters 35mm/s
Infill 60mm/s
Solid Infill 50mm/s
Top Solid Infill 45mm/s
Support Material 40mm/s
Support material interface 30mm/s
Gap Fill 30mm/s
(First Layer Speed) 20mm/s or 20%

Temp
Nozzle First Layer 220cel, Other 215cel
Bed First Layer 60cel, other 50cel

Retraction
Retraction Length: 0.7mm
Retraction Speed 35mm/s
Detraction Speed 35mm/s
Detraction Extra Length
Minimum Travel After Retraction 3.5mm
Retraction on layer change: checked
Wipe while retracting: checked
Retract amount before wipe 70%

Travel Height
0.1mm
(Other settings in this category are unchecked)

Support Material
Using organic at 45degree angle
Pattern: Rectilinear
Top and Bottom contact Z distance 0.2 detachable
Top Interface Layers: 2
Interface Pattern Concentric

I'm still fairly new to 3D modeling, but I put about 10 hours into Fusion 360 over the last few days to get the tolerances and screw threads just right.

For the outer grip, I used CNC Kitchen's Bump Mesh tool to create the hexagon texture.

The case holds 5x SD cards and 8x MicroSD cards. It prints completely without supports, and there is a dedicated groove for a O-Ring right below the thread to keep everything dry during outdoor shoots.

Let me know what you think! Feedback or suggestions for improvement are always welcome

Chiedo gentilmente, aiuto, a chiunque possa aiutarmi con la mia Artillery Hornet, comprata di recente usata a poco, ho già iniziato a prenderci la mano e a revisionarla quando da problemi. La mia richiesta si concentra sul fatto di volerla migliorare in modo da poterla sfruttare al massimo, esempio estrusore direct non più bowden, firmware klipper al posto del marlin, e cose così. Accetto e aspetto ogni messaggio! Grazie anticipatamente a tutti coloro che mi aiuteranno!