r/Godox

I tried to attach a Godox iT30pro to my SONY ZV-E10 using a Smallrig 3538B cage, but the cage interfered with the iT30pro, preventing me from attaching it. Therefore, I considered using a Godox TR-S as a riser. However, that also seems likely to interfere with the cage, so I haven't purchased it yet. I would appreciate any advice on how to attach the iT30pro while keeping the 3538B attached. Any configuration is fine as long as they don't interfere with each other. Ideally, I'd like a method that allows me to use both TTL and HSS functions. Any advice from experts would be greatly appreciated.

Hi All, I have a x3 pro, v100 and QR-p90T and an IT32 which I use for studio photography. Noticed that the gear is not good enough for full length photography so planning to get a AD200 Pro II and another softbox to address the full length requirement. I'm thinking portable since I shoot in different studios and have to bring the gear and set up. Any suggestions aside from the SBFW line? I was thinking of the QR P150T.

TIA!

Hi, I have a couple of AD200 Pro II units, and I'm looking for 3D printer files for a few accessories (like grids, snoots, etc.). I see models for other Godox flash heads, but not having much luck with stuff for this model. I usually use the Fresnel lens head and not the bare bulb, if that helps. Any pointers to models?

Edit: for the people sending me DMs, I can design my own, just looking for something ready to go to save time