Help Needed With Fan Motor Disassembly!
Welp, it happened again 🤦♂️
Hopper was completely - and I mean COMPLETELY - full, and water got inside and expanded every last one of them.
I’m attempting to take the motor out to remove the auger to clear the obstructions, but the pin and nut holding the fan motor in place was installed upside down. This happened to me before on a previous model, and I’m not exactly sure how I got it off, but now it’s also like that again on my Phoenix Onyx model. Like WTF is the manufacturer and assembly line techs thinking when they put these together?!
Has anyone else had this same issue before, and, if so, how did you remove it? I can’t even tell if it’s a small Phillips head or an Allen wrench head. So frustrating, to say the least. Thanks in advance for any input and assistance you all can provide.