r/SovolSV08Max

I'm about to start building my SV08 Max that's had to sit for a couple of weeks before I had the time to start the build.

I know there's a fair number of modifications / improvements possible but there doesn't seem to be a comprehensive list along with "howto's" on available mods, therefore I'm going to make one for my own usage and will make it available for anyone to view.

Please post your suggestions below with any links you have (and if such a thing already exists, please point me in it's direction).

Thanks in advance.

Print was going well until it wasn't. Need help to figure out what is going on. Logs and video linked as a zipped file.

1. This is a new SV08 MAX with enclosure.
2. Filament is Overture PLA Pro. The filament was dried in the SH03 filament dryer with stock settings according to instructions.
3. Default profile on OrcaSlicer 2.4.2 for both the printer and the filament was used.
4. I manually slowed the print down to 70% about 10 seconds after the print started.
5. I have had other "tall" prints fail in much the same way. Only big prints like this one (400mm wide and 400mm tall range of objects) are failing. Small prints are fine.
6. One thing I have noticed is that the printer is generating so many G-forces that the magnetically locked glass doors RATTLE during the print. The whole workbench wobbles from it (hence the printing speed slowdown I did).
7. Code modification: I've done are tweaking the auxiliary filament feeder to not make as much noise (slowed it down).
8. Code modification: Changed the heater bed to include a PWM Cycle change to 49Hz (can't remember the exact code but that's what it does) to eliminate lights flickering in my house from the bed heating up.
9. I've noticed strings and small blobs occasionally being thrown out. I've done a full days worth of calibrations but opted to use stock settings for this first run.
10. I've run a full set of calibrations on the machine itself (including PID).
11. At time 19:00 or so there is a dip in memory from a steady 579k down to 542k that does not occur anywhere else. I think this corresponds to the error in printing but I am not sure.
12. I have also noticed a temperature spike in the Host that occurred during the memory dip at 80C. I know that around that temp magical things start to break other magical things. Do I have a motherboard cooling issue??

https://preview.redd.it/eeupg6l14ujh1.png?width=706&format=png&auto=webp&s=e27e3d700079efaa73dead34933fb503d3df74ab

Heyaaa...so my Sv08 max tries to unalive himself all the time and i am Just using some sovol petg at 250C. How do u Guys prevent that? I fond that hotend horendous to Work with