▲ 9 r/seadoo
Grab bar pole mounts
Wanted an option to take the ski out fishing without having to load up all of the gear. Now, a pole and a few pieces of tackle is all I need to take with me.
u/175_Pilot — 2 days ago
▲ 18 r/jetski
Grab bar clamp on rod mounts
Sure as heck wasn’t drilling holes in my ski and just so happened to have my scanner and printer set up. See y’all on the water!
u/175_Pilot — 10 days ago
▲ 12 r/Plumbing
Settle a debate
Person A has a glob of leftover shredded chicken about the size of a golf ball, maybe slightly smaller, on their fork as we’re cleaning up the kitchen.
Person A tosses said glob of chicken down the hole for the garbage disposal. Person B says that should have been tossed in the trash - that while it is a disposal, it’s not really meant to toss large chunks of matter / leftover materials into that could otherwise be tossed in the trash. It’s instead only there to handle the small bits that may be leftover on the plate.
Person A challenges the legitimacy of person B’s claims.
Is person A or person B correct?
u/175_Pilot — 28 days ago
▲ 251 r/sandiego
Look up and to the west
Venus and Jupiter are up there glowing for us.
u/175_Pilot — 2 months ago
▲ 8 r/Plumbing
Is this a soft water loop??
No one can give me a straightforward answer so I’m turning to the folks on Reddit. Is this or is this not intended for me to loop in a soft water system?
u/175_Pilot — 2 months ago
CNC jr. mill upgrade to Linux CNC and GRBL
Long comity short - got a smoking deal in this mill. CNCmasters was the original driving software and system that was attached to the machine - they wanted roughly 700.00 for the software and well, I’m a cheap ass so I refused and wired it for an arduino and GRBL1.1
Heck yes open source cnc
u/175_Pilot — 3 months ago
Finally my little garage shop is getting somewhere.
u/175_Pilot — 4 months ago