u/4Real_VR

So far everything has been smooth sailing and I couldn't be more pleased. I installed the latest android app and updated smoothly to the latest firmware v2.3.27.16 after adding the device. Mapping around 1/4 acre of lawn in 3 areas went without a hitch and Bluetooth had great range for manual control and mapping. The mower was very fast and efficient at mowing for a couple hours I was testing it. Was very accurate with tracking and I didn't miss the RTK or NetRTK at all. Lidar is good stuff!

Only gripe I can think of is I couldn't find a way to set stripe pattern for each individual area, it seems to be task based only? Seems kind of silly because different areas definitely benefit from different strip patterns for efficiency and/or looks. Also, I set it to go to sleep mode while in standby on the charger but it still just shows standby mode in the app even after a couple hours of sitting on there. Should that status change to sleep?

Went through a few hours of setting this unit up only to discover that it can't mow the back .04 acre section of my lawn. It's just too thick and dense there and the mower constantly gets trapped after 5-10 mins of struggling. This is after mowing it to 3.5 inches with my gas mower. A shame because it does great on all my other areas where grass is less dense. Do you think the AWD version would do alright in this scenario if I upgrade to that?