

😏 it’s on like Donkey Kong!
Been trying to fine tune my 300 blackout to run subs suppressed on super safe. Finally said F it and grabbed a KAK DBC BCG! Time to go broke! 🥸


Been trying to fine tune my 300 blackout to run subs suppressed on super safe. Finally said F it and grabbed a KAK DBC BCG! Time to go broke! 🥸
8.5 inch 300 blackout, to sum it up this can on this gun sounds like a nail gun that roofers use with subs maybe a lil quieter but it’s sooo nice. Ran a mag of supers on super safe and it was surprisingly quiet as well.(may have been that can was pretty warm by this point idk) but I love this setup!
I don’t always use big bro’s Nike discount, but when I do it’s str8 heat 🔥🔥
Air temp unit, coil pan is bone dry, I blew the drain lines out 4times and found this at the end. Very top of the header box is water coming out the seal. I don’t wanna patch it with silicone but the part is almost out of stock most places. Should I just tell the customer the drain pan will have to be vacuumed out until this part can be delivered? (Drain pan fills from this leak and trips the float switch(no drain line/very stupid I know) every few days or so.
So, I have an 8.5 inch 300 blackout fixed gas block, cmmg zeroed 36k can, aero xm15 lower. Mainly shooting subs but I’ve tried basic carbine spring and buffer, h3 buffer w/ carbine spring, h3 w/ sprinco yellow, carbine buffer w/ sprinco yellow, h2 sound mitigation buffer(which I knew would bolt bounce) but everything I’ve tried is giving me light primer strikes! Anyone got a know fix for this type of setup? Hammer, trigger, and bcg are mil-spec.