u/AdOtherwise5656

I already load and hunt with their subs but want to hear first hand experience with their supers

Does anyone know what kinda changes you can make while building your form 1 suppressor compared to what you submitted and were approved for?
Like change diameter by .25”, length by so many inches or even material, stainless instead of aluminum, etc
I know the model/serial would have to remain the same and once it’s built it can’t be changed but while your making it you need to alter your plan

Just submitted a form 1 for an integral suppressor build for a .458 socom. I’m pretty new to the form 1 world and haven’t even bought materials yet. Wrote in the submittal it would all be stainless. A few questions to guys who’s made them before.
-I know I have to drill the barrel after the gas block but how is everyone mounting the can to/over the barrel? Basically how does the back end cap attach to the barrel?
-Is there usually a hard divider separating the expansion chamber(part over the drilled barrel) from the blast chamber starting at the muzzle?
-if there’s is a divider, is it solid to stop or ported to flow gas into the blast chamber?
-is the threaded muzzle still the main point of connection to the barrel? Basically a bravo hub but in the middle of the can instead of the end

Is there any resources for design ideas? I did some searching and couldn’t see much

Anyone else have keyholing after switching to a Faxon 7.5” 1/5t .300 blackout barrel, shooting subs?
I wanted to start loading Makers 240gr (already loading 200’s)so I switched from my psa 1/8t to a Faxon 1/5t but I lost all my accuracy and keyholing on all loads at 50 yds. No diff w & w/o a can on.
I was hoping for an upgrade and now it seems like it’ll go in the scrap pile