u/Anarcotik

I usually print smaller object with gyroid infill and that's my first time with a longer print, around 11 hours, and i wanted to go with adaptive cubic. I checked some posts about this kind of trouble (messy infill + i could hear nozzle hitting it from time to time) but I'm still not sure about the fix. Should I change something about Z-hopping ? Changing temperature of the nozzle or slowing down the print ?
Also I'm printing at 0,08mm with a 0,4 nozzle and didn't touch any other settings, I could probably go with a 0,12mm layer without much loss of quality if that helps ?

Printer is Bambulab A1, using Bambu Studio
Filament is a noname brand with recommended low speed temp 205-215°C and high speed 215-245°C

Nozzle at 220°C and bed at 65°C