u/Annual_Radio2325

Don’t know what to print and need ideas

My friend recommended using orca which I’m ok with but what settings do you recommend for detailed but strong prints I’m using 1.75 pla .4 nozzle any help is appreciated and what is the best way to make sure my base plate is level and close enough

I have temporarily epoxy landing year back on the timber my dad and I have some leftover fiberglass from building our vans RV 10 so we’re planning on fiberglass in the landing gear onto the frame. Does anyone have any suggestions on how to make it go well or is this a bad idea?

Hello everyone new to the hobby. I recently acquired a horizon hobby night timber. The only problem was that the landing gear was snapped off. I had used 30 minute epoxy to reattach it and took it out for a flight today and sadly it didn’t last I was wondering if any of you had a suggestion to increase the durability of the landing gear specifically the part where the landing struts attached to the air frame (the part that broke is the plastic that is inside the fuselage that attaches to the landing struts)