Moin, ich habe eine Pfanner Gladiator Hose, bei der auch die Waden bis hoch zum Knie mit dem Gladiator Material verstärkt sind. Wo bekommt man die? Online finde ich die Hose nur mit dem Stretch Material an den Waden.
Gerne auch alternative Vorschläge für Hosen, die am Unterschenkel ringsum vor Brombeeren und co schützen
Die Hose habe ich mal geerbt, sodass ich den ursprünglichen Käufer nicht mehr fragen kann.
Overhang test shows one droopy edge that's really pronounced on the 80 degree mark.
Noob here trying to dial in Elegoo PETG rapid on P1S. More cooling and going slower really helped with overhang quality but I can't work out that edge.
Nozzle temp: 260°
max vol. speed 21 mm3/s
Flow ratio 0.9576
40% part fan @ 20s layer time
85% part fan @ 10s layer time
100% part fan on overhangs
0% aux fan
200 mm/s walls
Overhangs: 25mm/s@50%, 6mm/s@75%
Does the top layer look over extruded? Not quite happy with the finish and I suspect I might be too stupid for the flow rate calibration
What are these tiny defect right next to the right side of indents in X/Y walls (for example at the Bambu logo in pic 2) and is there a way to get rid of them? Also the one Y wall shows tiny ripples (pic 3)
Just did my first full filament calibration but I'm unsure if that's a good result. But waaay better than standard profile. Printed on a P1S in Bambu studio with Elegoo PETG Rapid @ 0.2 layer height, 260° Nozzle temp, 1.0925 Flow ratio, max volumetric speed 21 mm³/s, 0% Aux Fan, 33% Fan, 200mm/s layer speed
First real print. The same wrinkle also printed below the whole on the other side.
Designed the piece in Onshape and printed the stl on my new to me P1S in Elegoo PETG rapid.
The wrinkle doesn't impede the function at all, but I'd like to know how to avoid this in the future. Thanks in advance!
Elegoo PETG rapid
P1S
Profile: Bambu hf set to 255°C
Layer height 0.15 mm