With this incredible design and fine details the Snapmaker U1 makes light work on this. All in all less than 24 hrs with no poop.
u/Baltisaros — 20 hours ago
▲ 28 r/snapmaker
One of my favorites thus far. 26 hrs at 0.16 mm layer height Used rock variable color PLA, black and white
u/Baltisaros — 29 days ago
Robo turtle in the house. 21 hrs at 0.16 mm layer height.
u/Baltisaros — 1 month ago
Cooling solution for under $25
For under $25 I installed this extraction solution to reduce heat in the chamber while keeping noise down. I know some people don’t have heat creep but living in Texas is a challenge. Even with the house set at 76F (AC) my printing room averages at 82 F, three printers.
I print a lot of silk filament which is notorious for swelling as a result of heat creep in the extruder.
note- the main reason I got the pop cap was to reduce noise. I don’t need a heated chamber. I already have printers with that. The pop cap does reduce noise but the flip side it traps heats needles to say. With the cap on the chamber goes up to 47C which is an issue for me as I print a lot of silk. With the fans the chamber temperature goes down to 33 C which is more than adequate.
u/Baltisaros — 2 months ago