I picked up an Anderson AM-10/AR-308 handguard dirt cheap, but since Anderson is defunct I’m having trouble finding the barrel nut wrench. Does anyone know what generic wrench or alternative tool fits the Anderson barrel nut?
I know I can do it and it exists, I just want to see if anyone else is running this before I commit to one? I’m just worried about the harder recoil being too much and eventually cracking the lower? I mostly just don’t want a failure in the field. It would be mostly 8.6 blk but sometimes a 6.5 cm upper.
Hello,
I am looking for a 5080 reference waterblock. I am also looking for a 27” OLED monitor, trying for 250 shipped if that’s possible.
Please comment before DMing
Hello,
I am looking for a 5080 reference waterblock. I am also looking for a 27” OLED monitor, trying for 250 shipped if that’s possible.
*Please comment before DMing*
Hello,
I am looking for a 7900 XTX with a waterblock, it does not have to have the original air cooler included.
\\\*Please comment before DMing\\\*
Hello,
I am looking for a 7900 XTX with a waterblock, it does not have to have the original air cooler included. I am also looking to purchase a 1 or 2 TB NVMe SSD under 100/TB in good health. It doesn't have to be 100% health but I do want it to last for a while.
\*Please comment before DMing\*
Hello,
I am looking for a 7900 XTX with a waterblock, it does not have to have the original air cooler included. I am also looking to purchase a 1 or 2 TB NVMe SSD in good health. It doesn't have to be 100% health but I do want it to last for a while.
*Please comment before DMing*
Hello,
I’m looking to buy two total DGX Spark/GB10 workstations. I’m open to buying both from 1 user or 1 each from two different users, it doesn’t matter to me.
Comment first before DMing
Thanks!
iPad Pro M5 WiFi or cellular• 13" or 11”• Magic Keyboard bundled in preferred
Please comment before chat
Hello everyone! I'm looking for a waterblock for my 5080 but I don’t want to break the bank. If anyone has one they would like to get rid of comment and then PM me an offer and we can talk! Thanks!
I wanted to ask somewhere on Reddit before I go through tearing this motherboard out, is there a better way to remove this microSD card? I was writing to it on the laptop and then when I was done and ready to remove it instead of popping out it just pushed further in to where no part was exposed. The pin on the right side has it jammed so hard against the left I can’t get anything on that left side and the port is so tight I can’t even really get anything in there thicker than a piece of painter’s tape but that isn’t sticky enough to pull it. I’m open to any ideas because this motherboard is going to be a pain to take out, get the card out, and put back together.
Budget: Looking for as cheap as possible, RAM size doesn’t matter so I don’t want to pay a premium for higher RAM size.
Use case: VirtualHere USB server for Moonlight/controller passthrough over wired LAN.
Need:
Real/native Gigabit Ethernet, not Ethernet attached through the USB 2.0 pipeline
USB host port for controller dongle/adapter
ARM64 Linux support preferred
Stable enough to run headless 24/7
Equal or better expected VirtualHere latency than a Radxa Zero 3E
Please comment before PM. Thanks!