Help! 3D printer is acting weird 🤔
Hi everyone!
So for specs
I'm using an Elagoo Neptune 3 printer
PLA filament at I believe 1.75 mm?
Elagoo cura splicing software
Printing at 15mms for the first layer and 50 mms for then onward
To preface I have finished modeling for the first time a project now onto 3d printing. I have 3d printed odds and ends before! Including their little test Buddha statue thingy!
I finished printing the first part as well! However as this is a multi part structure I immediately wanted to try queueing up the next part but now the 3d printer forgot how to print? Unsure.
Usually when it starts to print it will go to the center and Zero it's Z axis then go to the left hand side making two strips and finally starting the print.
Instead the printer now moves to a few spots pretty quickly before the filament or bed have even warmed up, does not even attempt to actually use filament, will start trying to print-ish in the air? Like wayyy higher than it needs to be, and then finish in like 5 minutes complaining about the filament?
A video is attached above.
This one strikes me off cause I changed no settings and all of a sudden it just bonked?
P.s. I have tried the factory settings reset and that did not help sadly.
Please any and all help is very appreciated!!