Arm stuck down
Phrozen Mighty Revo 16k
I had started printing again and everything was going fine. I heard a sound and checked. There was a bit of cured resin in the vat for some reason. I cleaned it up and started a new print a couple hours later.
Everything seemed fine when I started it. Let it go for a while and then checked it when I didn't see the arm move. It appears to be stuck down now. I got the vat and plate off without issue, and it does look like it did the first few layers of the raft before it happened.
There wasn't an error saying anything was wrong. The only one I had was two prints before saying it might fail and giving me the option to ignore. I ignored it the second run after reslicing the file.
Any recommendations for getting it lifted again? I did try the controls after turning it off thinking that might clear it . I hear the motor but no movement.