u/Dudebythepool

570 Watt 52.10 Voc 43.71 Vmp 13.81 Isc 13.04 Imp

so delta has 450v available so would it be 8 or 9 that would fit? Also the minimum amount would be 3?

Bought it so it can auto charge when it gets power but its stuck in manual mode, i can't find a way to change this in the settings but it is possible reading online. Anyone know how to its the newest version charger

cold pull works fine but printing just brings up extruder is not extruding normally error. Been about a month going back and forth with support.

only trying basic black/red pla

so far have replaced multiple hot ends and sizes , Extruder Servo Motor, and extruder filament sensor and Hotend Heating Assembly.

Anything else I should ask for or try printer is at 1600 hours worked great till this happened and now its been down for over a month