u/Durghan

For some reason my seams on my support are buggering up like this. The right, mostly vertical side is where the seam is, but I have no idea what the jagged side is doing. I've tried adjusting seam settings but that doesn't seem to affect supports. Any thoughts?

Thanks.

This is the first time I've seen Mateo not be at the end of a route. Can he be anywhere on a route now? Or is this just some glitch?

Anybody have any idea what the heck is going on here? The middle purple one is my latest attempt and it's got this weird stepping thing going on. Both purple ones SHOULD look like the orange one but at seemingly the same point in the print, it starts shifting over for some reason. And yet as you cam see with finished purple one, at some point it decides to just keep printing fine again. I don't understand what's happening so have no idea how to fix it.nany ideas would be great! Thanks.

So last week I either walked 64.4km, or a little over 14,000 steps. I'm pretty sure the 64.4 is the more correct value. I'm also pretty sure 64.4km is a few more than 14,000 steps. The week before I walked about 72km but my steps were only around 15,000 or 16,000. Anybody know how to fix this issue? The other values seem to be pretty accurate.

​

​

Hey all. So, I set up a print last night before leaving the house. When I got home, all 4 thumbwheels had completely fallen off, and my print was ruined. You can see the failure in progress.

I can see maybe one falling off if I hadn't checked in a while, but certainly not all 4.

But whatever. I put them back on and proceeded to start the leveling process. While the nozzle heated up I went to the kitchen to grab a snack. While there I suddenly heard an absolutely horrible noise coming from the printer. I ran back to see what was happening and it seemed the printer was trying to lower the print head but the print bed was in the way! All I could was turn it off. Now there's a deep dent where the print nozzle was driven into the bed. Fortunately I didn't have the printing plate on so that hasn't been affected.

But the hell is going on? I'm afraid to do anything else now. I tried using lock tape but putting the thumbscrews back on just pushes the tape around. What else can I do to make sure the thumbscrews don't fall again. How do I run the leveling process without destroying the printer?

Any ideas are welcomed. Has anyone encountered this? Thanks.

Is there any pint in wasting g a raid passes on a common pokemon that can easily be caught in the wild? Like this Machop is a raid for me right now, but I've been catching them in the wild so is there any point in wasting raid passes (just a normal one even though the screen shot shows a remote, definitely not wasting a remote on that!!!) on these Pokemon?

First noticed this last week but figured I'd wait till today to investige further.

I caught a Scyther and was given the option to add it to a nearby showcase. Habitually sent it to the professor as I backed out to see where the nearest Showcase was.

There is no Showcase within sight of my position!

I did catch a Pinser that let me add it to the Showcase so I did. I suspected showcases aren't visible until someone adds something to it so I figured I should see it now. But no. There is still no Showcase within sight.

I checked the pinser I put in and it showed me a location I knew. In this screenshot, the Showcase it got added to is WAY past that yellow gym in the distance.

I'm on a university campus, why is there no Showcase here? Seems lame. If this is the closest Showcase, that's at least a 20 minute walk for me just to get to it. Isn't that rather far?

So, what's the point of being able to use the mystery box more frequemtly if I have to wait so long for Home to let me add new ones!!??? Am I doing something wrong?