Well well well.
Firmware 4.3.9_3684 seems to have reduced artificial retardation. Got it via support.
We now have climbing ability 🥳
Will still prioritize threshold ramming before attempting climbing - but hey it's improved.
Update in regards to previous post:https://www.reddit.com/r/Dreame\_Tech/s/ervl0ncqOF
To mower continues to cut the 3 smaller zones twice regardless of the schedule settings. It always starts by cutting them first.
This is infuriating!
Moving cycle is off - as is also shown in the video.
Any explanation for this behavior?
Greetings.
After reading many reviews I settled on the L50 ultra, mainly because of its claimed ability to climb thresholds.
When it engages it's "climbing mode" it works perfectly. But it almost never engages it.
I have recorded a few videos. The threshold is 2,5 cm - 3,0 cm well within the robots claimed abilities.
I have manually and carefully placed the "passable threshold" via the app. I have taken care to try and center it right on the highest point of the threshold.
I have also added a virtual wall because the robot insists on trying to traverse the the threshold at the corners which adds further trouble.
Firstly It should be obligatory that the robot is forced to engage "climbing mode" at those specifically marked "passable threshold" locations.
Secondly, one should be able to choose at which directions it engages "climbing mode" at those locations.
Thirdly, the passable threshold should also be "no go zone " when not specifically used for traversal. The robot tries to clean it and to no surprise has a bad time doing it.
The current mode seems to belong under some sort of "let clean genius decide"
The hardware is so cabable - it seems purely limited by obscure software AI rules.