u/Dysfunkshin

Print profiles question.

I’m sure there was a reason but why was the “0.16 High Quality” profile removed from Snapmaker Orca? In the patch notes it says they were merged into “Standard”?

All it did was change speed settings correct? So if I choose standard and reduce speed it should be the same?

I used the quality profile a lot and just want to make sure I am understanding it correctly.

Thanks

reddit.com

u/Dysfunkshin — 9 days ago

▲ 3 r/snapmaker+1 crossposts

Rippling on top layer (ASA prints)

I am having some issues printing with ASA on my U1. I am getting a real bad ripping on all my top layers.

Print settings:

Bed: 100c
Hot end: 260c
Slowed top layer to 100mms
Chamber is at about 60c
I’ve ran bed level and extruder calibration
Layers @ 0.16
40% infill
Roll is new out of package

Any tips on a fix? Thanks so much.

u/Dysfunkshin — 1 month ago