u/Eric_Drav3n

Is it okay to replace my 6500 rpm 3v hair clipper motor with a 7200 rpm one?

So as the title states, my hair trimmer stopped working. The lights come on to tell me the charge level but the motor won't turn on. Haven't fully tested it by directly hooking up the motor to the battery without the circuit board but wanted to know if it would be bad to swap the 6500 for a 7200. Attached is the motor that may be bad and here is a link to the motor I want to replace it with. https://www.aliexpress.com/i/3256807957931353.html?gatewayAdapt=4itemAdapt

Also, just seen the battery is 3.7v but the motor is 3.0v, can I even hook them up directly to test?

u/Eric_Drav3n — 6 days ago

▲ 3 r/snapmaker+1 crossposts

I am using PETG as support for PLA, and the prime tower keeps failing on my U1. Obviously, it's because PETG and PLA don't stick to each other. So this brings me to my question. Should I even print a Prime Tower when I am printing multimaterial prints? Any help on this would be much appreciated, too.

reddit.com

u/Eric_Drav3n — 18 days ago