Hot wiring Johnson Outboard
Is there anyone that is able to layout step by step on how I can hot wire start my 2004 johnson 150hp outboard. For now I really just want to compression test. Eventually full start and test on muffs.
I have the key and ignition switch with 6 pin male connector on that
I do not seem to have the actual kill switch control. I believe its the black yellow wire which is one of the 6 in the key ignition switch.
From there I dont really know what I am doing on the engine harness side. Not sure what needs to be connected.
Another basic question I have is what studs am I powering on the starter/solenoid? Where is the positive going and where is the negative going?
I took a gamble on a used outboard on marketplace. Even if doesnt end up paying off it will be a few hundred dollar learning project to help me in the future. I am interested in learning becoming proficient in service on these.
Ive included pictures if that helps