Looking for an under desk pull on mount for Vocaster One, similar to what is made for Stream Deck
TBH, I am so new to 3d printing, and I don't even know if this is possible. Budget $50? Like, I truly don't even know if that's a lot or not a lot.
I have an idea for a custom under desk mount and was hoping to get some feedback on whether it's feasible and, if so, where I go from here?
The device is Focusrite Vocaster One.
I basically got the idea from Stream Deck Mounts. Like these.
So, basically it pulls out, but has a tray it goes into when not in use. I understand my Vocaster isn't flat on top, so the knobs are a bit of an issue. The second issue is there is a metal support bar at starts about .25 inches in behind the front edge of the desk. So, I think the stand would need to mount behind the metal and have some sort of spacer so it mounts, and drops down below the metal bar (1-2 inches is the size of the bar) and only then could I actually pull the drawer forward.
I can provide photos and dimensions if this sounds even possible.
Basically I am at the point where I have an idea, and it's so niche, the only way would be 3d printing, but I don't even know in the 3d print world, if it's possible.
If it is possible, i'd be happy to do a follow up post with pricing and everything.