u/GandalfIeGros

Hi, I just started learning FreeCAD and my end goal is being able to approximately model and print this small aircraft.

I’ve just started and right now I’m just able to import the picture, sketch above the profile view and extrude

I have a few questions :

- Is this doable for a beginner or I am setting myself to fail ? I’m a quick learner, and with all the support avalaible on YouTube, I’m quite confident I can do it, even if it takes a lot of time.

- What’s the best strategy ? Model the entire aircraft and then do the detail, or do every parts on the side (wings, fuselage, propeller, gears…) and then assemble them ?

Any advice is appreciated !

Just got this beauty, a Fender Player Mustang 90.

I wasn’t in the market for a new guitar (or so I thought ! ) but I saw it on window display at my local shop.

I’ve always wanted to try P-90s, maple neck and short scales, and this checked every box !

And this finish, can’t stop looking at it, the green almost turn blue depending on the lightning. It feels great, and the pickups sounds so good with every gear I tried !

Oh and the kitty approved, so I’m good to go !