Bendy Calibration Troubleshooting/Critique Klipper
I'm a total noob at printing but got an Ender 3 s1 Pro from my GM for super cheap. Its been a super fun headache. I set up Klipper on a Raspberry Pi (he was not running Klipper before), and have spent a lot of time troubleshooting; with advanced settings of course. Its printing fairly well, but I know there are some things I could do to make it print better/faster. I know speed isn't everything but....yes it is. With quality if course. Here is my 2nd bendy ever after going through some calibrations.
What do you think I could change to make this print better, and once it is dialed in quality wise, what are the steps to getting it faster, faster, faster!
Specs: (I'll post settings in comments)
S1 Pro - with added fan shroud that I printed to better focus air
Raspberry Pi w/ Klipper
Mainsail
Moonraker
51 minute Benchy (my first benchy without klipper was 62 minutes and looked worse)
Tecbear PLA+
230° nozzle, 57° bed
.20 layer height
.9 Retraction
.96 flow ratio
0.088 pressure advance (seems high), but my calibration test pointed to that number.