Got the FiTech installed and running.
A/C is installed, charged and cool.
Transmission is new
CVF serpentine system
3G 130a alternator.
I fabricated BMW seats with integrated seatbelts in, I wired them up to make them functional.
Again I need help.
These seats were supposed to be out of a 640I gran coupe I want to get them powered up and here are my wires. I found diagrams online but they look like Latin to me. What do I need to wire to make the seat functional? I included the diagrams I found online but they don’t make sense compared to my old ford diagrams. I just need to know the wires to make the seat functional.
I’m wanting to fabricate these seats into this 1965 Galaxie. Turns out the eBay seller I purchased from took the seat control modules/controller off. I’m awaiting the new modules to be delivered (not from them) but in the meantime
I have a few questions
I have a voltage reducer with a pulse generator to trick the canbus system.
In picture 6 I cut the plug end and have the
12v red/blue
Brown ground
Can bus orange green
Can bus green
Gray ??
Small brown???
I ordered these controllers at the last photo, is there anything else i need to do to make these functional. There are a few YouTube videos showing fabricating these seats into older vehicles I just want to make sure all my ducks are in a row.