u/HappyBottomSexToys

I got a prescription for 20 mg Viagra several months ago. I am on the borderline of needing it, but it makes an erection more of a sure thing and also makes it rock hard like I am 20 again (am mid 50s now). Generally I only take half of one and that works fine and only side effect is sometimes very mild headache next day.

I decided to try a different prescription of 20 mg Viagra and 20 mg Ciallis in one pill. The reason was because the Viagra part is fast acting, but the Ciallis part can last 36 hours and there are many times I take a pill and wife falls asleep or for some other reason and sex doesn't pan out so a pill that is still good the next day is better than taking something and it going to waste.

Anyway, reason for my question is that I took one for the second time last night and today I woke up with a bad headache and still have it four hours later. Not sure if it is due to the full 20 mg of Viagra since I normally get by with 10, if it is the Ciallis, or if it is the combination of both of them. Have not tried cutting these pills in half. I am sure that would work fine since the 10 mg of Viagra does, but then I don't know if it would still be effective the next day if needed with just half the Ciallis.

Any comments on if the headaches are likely from the Ciallis? Suggestions on continuing with the combo pills or just using the straight Viagra?

My ULS M-300 laser has a DB-9 connector to connect the rotary attachment. I don't have their rotary, but I do have one from a different laser. Does anybody have the pin out they use for the connector?

I have a Universal M-360 laser and their older lasers don't save jobs after powering off. I make my files on AutoCad and they have a print driver for the laser so you connect the USB cable and printing out of AutoCad sends the file to the laser.

It works good, but I have one problem. AutoCad is now on a subscription model and I don't always have a current subscription depending on what work I am doing and even when I do it is sometimes a real pain because it periodically has to go online and check your subscription status which is difficult in my shop with no WiFi.

Is there a way to save a print file to somewhere and copy it to the USB port later for files that I run often? In the old days of parallel port computers you could do that and then later or on a different computer copy that file to the LPT port.