Tinywhoop recommendations
Hi, had a blast flying my air 75 the past couple months and am looking to buy something with a little bit more punch (capable of 2S) any recommendations?
Hi, had a blast flying my air 75 the past couple months and am looking to buy something with a little bit more punch (capable of 2S) any recommendations?
Looking for a good replacement VTX (Rush Tank size / 20x20)
Having weird video issues on my setup: VTX drops out after ~15–20m, maybe 40–50m max when I aim a patch directly at it.
Already swapped the VTX with the same model, no change. RHCP on both goggles and VTX, all connections checked. Pretty sure I was out of pit mode when testing it.
Not sure if it’s setup related or just a bad VTX.
What are solid, reliable VTX options in Rush Tank / 20x20 size that actually perform well?
Getting “RF signal low” at short range and really bad video range, no idea what’s going on
I can still fly the quad, but I get random “RF signal low” warnings, sometimes already after a short distance. It’s not constant, just pops up randomly.
The bigger issue is the video. After around 15 to 20 meters the image is basically gone and just turns into noise. If I point my patch antenna directly at it I maybe get 40 to 50 meters.
I already swapped the VTX for the exact same model and nothing changed.
All antenna connections are properly attached. I’m using RHCP antennas on both goggles and VTX.
I can also 100% assure that all solder connections are good.
Receiver and antenna are both 868 MHz, so that matches. The RX antenna is new and connected via U.FL.
On my F4 the RX antenna cable runs between FC and ESC, so basically right through the stack. I think that could be causing some interferance right?
At this point I don’t know if both problems are related or two separate issues.
Any ideas?
This part broke after my KO MP36 Megatron fell off the shelf. I tried gluing it back together, but it wouldn’t hold. Then I tried to remove the whole part so I could make a 3D-printed replacement, but the pin just wouldn’t budge. If glue doesn’t work, I’ll probably have to cut the part apart to get the pin out.