u/Illustrious_Sell_325

Still new to the works of 3d printing. I am trying to print this SpongeBob box for my nephew. It has supports inside that are breaking free from the pla base. The ones on the plate are staying out. This is the third time it’s done it. Once with box tree supports and twice with the normal round tree. I’ve left support on auto not knowing what to adjust.

I have aux fan deflectors on both sides. Any ideas? This is turning into an expensive box lol

I was on the fence about a 3dp, figured I’d use it some and with a nephew and niece maybe I’d print a couple toys. LOL
This poor printer hasn’t stopped since Friday and I’ve still got quite the backlog. Had a few small mishaps so far but just part of the learning curve. AI detection actually worked when the fan blew the sphere off the plate.

I’ve already started to see a problem with filament hoarding. What are the thoughts on the fabric spool storage containers with a desiccant box put in them? Cheaper than cereal containers but less airtight. My Inside humidity is usually around 50% damn tropics

Kitty tax. He is fascinated by the new box that magically made him toys.

Boy do I have a lot to learn still!