u/Impressive_Whole9731

​

EDIT: When i was printing a benchy, the printer stopped extruding mid print while still showing the previous issues

Hey everyone. I recently upgraded some parts in my ender 3 v2 (extruder arm, nozzle replacement, bowden tube replacement). I recalibrated esteps, performed a PID autotune, releveled the bed. After replacing the prints have major layer gaps and weak infill. I have used a brand new filament to make sure it's not wet, but it gave me the same results. I really dont have a clue how to fix this. I provided 2 images. The 1st one shows a layer gap on the upper part of the X. The 2nd shows the weak infill. I never had an issue like that before.

Slicer: Cura

Settings: Default (worked fine for me)

Profile: Dynamic

Printer: Ender 3 v2

Temps: 200/50 (nozzle/bed) C

Material: Devil Design PLA 1.75mm black

EDIT: Image in comment. When I was printing a benchy, the printer stopped extruding mid print while still showing the previous issues

Hey everyone. I recently upgraded some parts in my ender 3 v2 (extruder arm, nozzle replacement, bowden tube replacement). I recalibrated esteps, performed a PID autotune, releveled the bed. After replacing the prints have major layer gaps and weak infill. I have used a brand new filament to make sure it's not wet, but it gave me the same results. I really dont have a clue how to fix this. I provided 2 images. The 1st one shows a layer gap on the upper part of the X. The 2nd shows the weak infill.

Slicer: Cura

Settings: Default (worked fine for me)

Profile: Dynamic

Printer: Ender 3 v2

Temps: 200/50 (nozzle/bed) C

Material: Devil Design PLA 1.75mm black