Hi all, I've started seeing these what look like bubble pops appearing in my prints. First they where only showing at the top of the print on smooth surfaces but now seem to be showing throughout. Saturn Ultra 12K using Elegoo space grey resin. I've cleared the vat and reloaded via a filter to minimise contamination. Used different tub of resin of the make and colour.
Issue:
Brand new ultra 4 12K connects to WiFi but unable to see on network, no IP address and throws up error when connecting to account.
Every other device on the network connects fine where the printer is working fine so it's not location issue with the signal.
I can't do anything with it externally because it's not connecting properly. Router doesn't see it and why would it, there's no IP assigned.
Elegoo app doesn't work because I can't get to the "my account" page to get a pin or QR code to allow the printer to be 'seen'
Self tests come back green
Printer works fine otherwise, nice prints so far.
Tried:
Resetting
Removing the WiFi aerial
Moving the printer closer to the router
Name changing the printer to lowercase
Connected to different WiFi protocols including 5Gand 2.5G
Connected to my guest WiFi which doesn't go through Pihole
Changed the password on the guest WiFi
Hi all,
I have a Saturn 2 resin printer that has been absolutely fine until about a month, maybe 2 months ago where resin started drying on the build plate during a print. Longer prints are worse. I've double-checked all my settings. Everything seems fine. I switched to ABS like resin last night and this is was the result. As you can see it is worse. It looks wet but I assure you it's dry very difficult to get off. The only way that I've been able to do that is to sand it. There are no cracks. There are no leaks that I can see. I'm really at my wit's end.