I had a question,if the seller has a policy of "the product should be unused(no soldering should be done)".
If something comes broken without any physical damage (manufacturing defect) or something else.
Then in the case they won't give any returns.
What should be done??money wasted?
I got this drone part printed from an printing service but it's quite rigged The second picture has the part which had arrived from the brand and the first one is the printing Services
Print specs--0.2mm FDM printing
Material--Tpu flexible
Can you tell me which material I should use???. it needs to be hard and rigid(which does not flex)
And the printer quality what should I use???
And what is SLA printing??
I want to use analog for now but I will upgrade it to dji later
Could anyone suggest me google,camera,vtx some budget friendly ones could be great.
I had a question....I have a radiomaster pocket which has 250mw of power so does it make sense to have a higher power vtx than that??
Elrs range would be 2-3km then if
I'll use a vtx of 350mw or 850mw what would the range I'll get will it be <than rx
Specs---
Frame -speedybee master 5V2
Stack-speedybee f405 V5
Motors-T motor velox V3 1750kv
Elrs--speedybee nano rx
Props-gemfan hurricane 51377
The first fpv learning was a tedious process i first I had referred to a youtuber 'nick fpv'
Where he shows his 4' quad while referring to that I thought I'll use the same specs and build my own quad
Importing his frame was not an option so I got a decent sb frame i thought that will work
What I did
Bought a 5' frame,got sb f405 mini and tried to put 2004 motors on it
When it didn't i 3d printed a motor mount that ofc didn't work
So I just applied hot glue on the motors and flyed it later 1 motor broke and I didn't know what to do
Then it was me who learned things in 4months and here I am with the quad
Still I have not figured out the analog system🙂
In this flight controller,the port on the front is of elrs rx
So should I use the copper pads or the plug
Am I soldering to the correct pads ryt?
I have this confusion because on the left side where I have tinned are sbus or rssi are they used for the dji unit?? Clearly sbus is for pwm rx but what Abt rssi what is it used for??
The plug that is in the front is connected to any of the pad
If i use the plug would the pads would be useless
Means if I use the plug the pads that are interconnected can I solder something other with it or not
​
Problem 1---
After a crash i had to change the motor...
It might be less visible but the top right screw is not getting fully screwed it's only going in half way.
And the fact that it's stripped it's not coming out either
Is it safe to fly??? And how should I unscrew it
Problem 2----
I wasn't able to find a pigtail xt60 so I bought one without it and soldered 14awg wire
Now it's ripping should I resolder it or is it fine