So I have a warranty replacement lever action that has ripped the back of the casing off and left the rest in the chamber. After researching this apparently it isn’t to uncommon when running .38 then running .357 but what confused me is, the original one that got replaced would run either with out issue and I never cleaned the bore before running one or the other. Round after round this never happened. Gun issue? Ammo issue?
Purchased a 99 7.3 to haul my tractors around. I knew it needed work and I’ve knocked out alot of the bigger stuff. One small thing that is left is the drivers side front blinker refuses to work. Last owner had some Amazon special bulbs in it and I replaced them thinking they were going out and they aren’t. They work with hazards but not by themselves, I’ve checked the wires on the column and the fuses and relays. And I tried a new multi function switch. Honestly starting to think it’s a ground issue. Any other ideas? Anyway if it is a ground issue to just find the correct wire and splice in a new ground without running the whole length of the wire to find the issue?
Any input is appreciated as this is getting annoying