Tried to grab Bayonetta from the site and it downloaded in wux format. Can’t seem to get it working in cemu. Downloaded the key file and copied it into the cemu folder and no dice. Even found the key code for the game online and manually copied it into the key.txt file and still nothing. If anyone has suggestions or directions it’d be greatly appreciated
So a couple days ago I go outside and see my car’s rear lights are on. I don’t think too much of it and just hop in and drive off. On my way to my destination I’m going up a hill and notice it stops accelerating even though my foot is still pressing down on the accelerator. I immediately pull over, restart it, and continue driving afterwards. A few minutes later I get a message on my dashboard saying “hill start assist not available”. Not sure what it meant but I decide that it should be looked at asap. While I’m out I notice no matter what I do my rear and headlights won’t turn off (double pressing lock button on key and turning the knob next to the steering wheel didn’t work).
To no surprise I wake up the next morning and my battery is drained and I had to get a jump to start it. I took it to an auto parts shop and they said they couldn’t check it because my check engine light wasn’t on. I took it to valvoline and got my engine air filter swapped and battery tested and it was apparently healthy. As I was driving around the acceleration got worse to the point I couldn’t go above 40mph. Took it to a few mechanics and they couldn’t diagnose the issue. I called the local ford dealership but they said that they were backed up wouldn’t be able to look at it for a few months.
Really just weighing my options here. I don’t know what the issue is and some shops are charging me an arm and a leg just to figure it out. I’d rather keep my car if I can since I’m almost out of the note. Any ideas on what could be going on or suggestions on what to do would be really appreciated
Anyone have GameCube emulation working correctly on the steam deck? What controllers do you use? I’ve managed to get the games to work but I haven’t been able to get my GameCube controllers to work at all. My switch pro controller works but whenever I try to remap the controls it doesn’t work correctly. Any tips?