u/KnC_Neo

Hey everyone. I seem to be having an issue with my tree supports. I have recently changed from Cura and I am struggling a little bit. Most of the posts that show settings are old and several of the settings have changed or no longer present. I have been playing with the settings and I still seem to have thick and heavy tree supports and they are hard to remove. In one case a tree seemed to fuse with my model because it was so close or something like that. If anyone has current settings that work well I would really appreciate a look see and work from there. Thanks in advance.

Hi all, up until now I have had rock steady extruder temps. Recently my heater block stripped out on the nozzle and I replaced it. It has been working fine for some time. Then my hot-end fan died and I replaced that, everything seemed to be fine for a couple of weeks and now I am getting erratic temp swings on my hot-end. I am running Klipper and it stops on heater issues. I have loaded the settings and I have put in crazy number just to keep it going to do a PID loop set. I will complete it but now when I print I can see swings where setpoint is 198 and I can see swings down as low as 184 even though it is brief I have never seen this before in my printer. Could the new fan be too much for the heater? Is it possible to slow it down some?

Long story short. I have 3 spools of PLA from the same manufacturer, black, grey, and white. Black and grey have bed adhesion for days. I switched out to white and nothing. I have tried everything, basics z-height, bed level, glue stick, hairspray. Still nothing. I have done multiple steps from 200/60 at 30 mm/s to 215/65 at 15 mm/s. Still I can't get bed adhesion. Any ideas??? Can color really matter?