I just replaced my rail with a Midwest Industries and I installed a magwell, extended mag release and grip with strike industries. I also installed the strike industries selector switch. This was in a bag leftover, not sure what it’s from. Any ideas? It’s only about 3/4 of an inch long. Rounded on one side.
So I have a performance machine brake mount with a brake stay. My dumbass put a spacer outside of the mount thinking it was fine. I didn’t think about the wheel cutting into the mount. Should I run it and let it self clearance, as the mount as incredibly beefy. Or should I cut the spacer in half and put half on each side of the mount? It doesn’t look like there is much room for the brake to move out any more without rubbing the inner pad. Thanks for the help everyone.