u/MMeNDtal

Hopefully this is OK to post here, but please delete if not.

I went to use this today, and it switched on, but then died after a few seconds. Switched it back on, and it did the same a couple more times, then worked for a minute or two, until I switched it off. Then, it wouldn't switch on again.

Fuse is good, brushes are good. Pulled the switch and that's also good. Not sure what else I can test with a multi-meter, but the LED isn't coming on, which makes me think it's a faulty controller (also, is the controller supposed to have that 'bulge' on the right hand side)?

Was hoping to get some thoughts, before blindly ordering a new part... TIA!

I'm in the UK, looking for a PA 1-6x24 scope, and I spot this on SPECPRECISION.

Normally, with replica scopes, they don't name the brand they've copied (Like RZ instead of Razor, or specify it as an Evolution Gear VUDU), but in this case, they've listed it as being original Primary Arms?

I reached out to chat, and they're insisting it's the real thing, but when I asked if it's covered by the PA warranty, they said no. There were other inconsistencies, such as claiming it's a green dot, when the pictures show red, and that it's a Gen III, when a Gen IV is shown.

Has anyone here bought one of these, specifically?

Designed by myself, from scratch, and MJF 3D printed in PA12 nylon. The suppressor has a spring loaded catch, and locks securely in position. Easily removed by pushing down on the same catch. So happy with how it's come out, and probably the coolest thing I've made, so far!

Might still add a torch, and possibly a LAM (although, it doesn't need to be much heavier). Waiting for a SAG skeletonised M4 adapter to arrive from the USA. Will swap the stock for a Magpul MOE RL when that turns up (this one doesn't fold flat, with the side rail bracket).

This is the second set I've received from the same retailer. While the first set had KRISS embossed in them, this set has DEFIANCE. I was under the impression that these are Krytac licenced airsoft replicas, but the shop is insisting they came direct from KRISS.

Fits over a standard, unmodified S&W 15-22 magazine (other than replacing the base plate with my own version). Slides on, and clips securely in place, with no tools required. Eliminates pretty much all remaining slop, even when using a Boonie Packer 'Better-Mag' adapter, but still ejects cleanly.