
What is this hot wire off of alternator?
This wire had been like this for months. Where does it go? I hit it with a wrench and it is hot.

This wire had been like this for months. Where does it go? I hit it with a wrench and it is hot.
My fan clutch broke off and my truck doesn't want to start intermittently. And when it has trouble starting it takes a little to get up to idle once it does. Other times it starts fine no problems. I'm looking for wires the fan may have clipped but see none.
I pulled a plug wire off the front cylinder and it started up when having issues not starting. Put a new plug in and now it will start but sluggishly and battery light came on. Any ideas on what to do is appreciated.
My fan clutch broke off and my truck doesn't want to start intermittently. And when it has trouble starting it takes a little to get up to idle once it does. Other times it starts fine no problems. I'm looking for wires the fan may have clipped but see none.
I pulled a plug wire off the front cylinder and it started up when having issues not starting. Put a new plug in and now it will start but sluggishly and battery light came on. Any ideas on what to do is appreciated.
My clutch fan broke off violently and now my truck doesn't want to start all the time and is idling somewhat rough intermittently. I pulled a plug wire and it started so I checked and replaced that plug but still having issues. Not sure if ignition coil is failing or where to look. Any helps is appreciated.
Washington does not sell r134a anything to the public. I have ordered two different conversion kits and low pressure doesn't fit. I need fitting for high pressure. Not sure. Any help is appreciated.
New electric fan wired in hopefully no issues with this set up. I used the check relay for ignition power, got a 30 amp in line fuse in. First time doing this.
I have an electric fan with thermostat that I would like to splice into a wire under the hood that only gets power when truck is on so it doesn't run once truck is off. Any ideas?
My fan clutch broke off due to a wreck the pre ious owner was in and didnt fix correctly. I have oe parts coming or an electric fan that I can wire in but not sure where to put thermostat for the electric fan. What do you guys think is a better route to go?
There is a needle like pin above belt? And to the left, of the picture view of the needle, a rounded block piece attached to lower part of engine that is leaking oil quite a bit. What are these two things?
I am wondering where I should start looking, to get AC to work, after I checked all fuses/relays and they are all good. the ac light comes on but nothing else happens. I am sure there is no refrigerant but not sure of what next steps to take. please any advice is helpful.
What tail light bulb goes here and whats it for? Trying to wire in a 4 pin trailer lights connector and just saw this.