u/Mia_Cauliflower

Hi everyone, I’m new to Klipper forgive me if I’m being stupid, I’ve been running it for about a month and a half, and last week I had to reinstall due to a problem with my raspberry pi. Since I’ve reinstalled my printer is way slower than it was before, I’ve put the exact same printer.cfg back and haven’t changed any of my slicer settings, it used to be a few minutes faster than the estimated slicer time but now it’s lagging behind by almost 50 minutes on what should be a 130 minute print, with no increase in quality. Where should I be looking first? I’m not interested in the fastest speeds possible but this is slower than stock now.