u/MikeE9983

Have it all mocked up, tomorrow I finish the stitching holes! Coming out like I had it in my head, so I think that is a win!

Giving thought to stitching through all four pieces, it's about 14mm thick.

Secondary option is to stitch the top two and bottom two.

The layers... Top to bottom

-Rivet cover (to keep the rivet from rubbing the knife handle)

-Snap closure, wrapping around the handle

-Main sheath body

-Belt loop strap

Going to use a rivet going from the belt loop strap up through the snap closure.

(First actual complete project, big time rookie)

Idk - should I just do the rivet and only stitch the cover to the closure???

After learning my lesson about trimming the welt while it was on top of the back... The re-design is going well!

Can I rewet the piece and go at it again to deepen a couple of these?

Please confirm my understanding ... All of the shaded red area should be a flat, straight surface from the spine to the apex... Correct? Like for the smaller two blades the red should be flush with the stone.

Am I getting this correct?