u/N8TVgamer360

This is a first for me… the nozzle tip broke off and also engraved the plate. I installed a new hot end.

I have tried 3X to print TPU, specifically the CR TPU. I did see a person had done a mod for the extruder for a K2 Plus. Taken out the spring (Tension) and used a lighter spring. And made some changes in the setting. Some advice would be appreciated.

Thanks!!

So I have two of the newer SpacePi X4L and I am getting an E2 error. So the first thing I wanna do, of course is troubleshoot and update the firmware… well there is no place to put a USB or a micro SD card or an SD card. In the device, Support has not been any help at all and I keep trying to let them know that I don’t have the older model. I have a newer model. So any help would be appreciated.

I first tried to print on end and it was knocked over then I laid it down and still made a mess trying to print.

I gave up after two try’s now on to my next project.