u/NewEdgeStangg

So it is a 1996 Ranger 3.0 with an automatic (trust me I prefer manual too) however on the original motor and trans I got 280k out of it. Then for about $1500 I put another engine and transmission in it myself. Currently at 114k on the new one. Body overall has seen roughly over 400k miles but unsure since the odometer didn’t work until recently. It has been tinted to 35% all the way around picked up the $1k weather guard box for only $150 and while I was still in high school I wired in heated and power seats form a 2003 Explorer Sport and got the console from a early 2000’s sport trac and swapped the STX valence on it and wired my own fog lights. Everything else is mostly aftermarket cosmetics such as lights all the way around… but for 30 years old as a my daily at 19 while I go to school for aviation maintenance… it ain’t bad, but what yall think?

So I just started drifting in assetto, yesterday everything was fine no issues today I got my handbrake and shifter and connected and setup. Then I tried to load into the map and immediately all I see is grass. No control over assetto after starting the drive… have to unplug and restart the pc to do anything. I found a similar form from years ago and tried every suggestion which is listed below:

Disable CSP
Different car and map
Use extended physics
Change spawn points
Reset to default
Reinstall map and relaunch
And downgrade to previous CSP version

None of this has fixed the issue, not sure what to do next. Hope someone may know the solution to this, thanks in advance!

Photo attached references the issue:
CSP Version 2.11