











DIY board
Some of the process of making the board at the end.
I used an IKEA pegboard, cut it so it could fit in the bag I had (12.25” x 22”). The rest I used wood from the hobby board section at Home Depot. 2.5”x0.5” poplar for the underframe of the base layer, and the back support of the top layer. Red oak for the top layer and the back to add nice natural grain on the back, as well as support. The legs for the top layer were from my old gokko pedalboard.
Sanded the wood applied red cherry stain, a polyurethane spray finish.
Here is my signal chain:
Polytune -> pulp n peel -> Gladio (clone) -> POG2 -> sunset -> jb2 -> chroma console -> layers -> D1 -> R1.
The graviton is set up for controlling the delay and reverb (D1, R1) as well as the chroma console