Completely lost and in need on some assistance!
Hello all, I've been wanting to get into the hobby for a few years now, and I came across Bambu's anniversary sale a few weeks back. I bought the X2D with AMS 2 Pro combo. I added a second AMS 2 Pro and an AMS HT. Also, I got the filament track switch to make it all seamless.
I received the X2D combo a few weeks before the 2nd AMS 2 Pro and AMS HT arrived. I have to say the initial setup and first few prints went flawlessly. However, the nightmare began the moment the rest of my order showed up!......
I am getting the same two errors over and over, and I've trashed 3 spools' worth of prints so far because I had to stop them in order to address the errors. The first error is filament friction, and the second is that the extruder motor is jammed.
I have tried countless lengths of PTFE tubes between every possible connection. I have the 2.5mm ID tube as well and even tried the PTFE tube with the star-shaped ID.
My current configuration is as follows. My main AMS is hooked to the top slot in the FTS, and the second AMS & AMS HT are connected via a 4-into-1 splitter to the bottom inlet of the FTS. The only long PTFE tube is from the AMS HT, since I have it set on the left side of the printer. I just ordered a TPU Assist Module, thinking that I might be able to add it somewhere in the system to help boost the feeding to stop or reduce the friction somewhat.
I have a total of 360 hours printed on the machine. The last 120 hours only with the full setup. I'll link some photos of the setup. I also got the A1 combo at the same time and have had zero issues with it.
I am trying to print the BLV riser, but each section takes 32 hours if I enable the different material for the support interface. And when I don't select a different support material, it just sticks to itself and ruins it anyway.
I would be extremely grateful for any help or suggestions.