Hey all! This is aimed at any of you still rocking the Creality CR-20 PRO. How did you end up set your printer up in orca slicer? There isn't any preset for this printer and when you go to make a new printer it requires a preset to import and base the setting off of. What did you use? or did you go about setting up your printer in a different way?
Any help/advice would be greatly appreciated!
Hey all, just wanted to ask you about a problem I encountered. I tried running a temperature tower test. I set up the temp changes in the post processing scripts and made one for each section. The print was going good for the first layer but after that one was down the temperature switched to my default pla temp. I am going through the settings now and I am not sure where I went wrong.
the apply to setting is set to subsequent layers so it should apply from the set layer till the next change specified in the next script. I tried going back and setting a range in the change layer but there is no way to add multiple layers in that box so I am at a bit of a loss.
Any insight would be greatly appreciated!