E36 gauge cluster
I need help. I’m trying to set up my e36 gauge cluster. So far I have only gotten the Speedo to work. Fuel, temp and rpms are dead.
After 3 days of scratching my head I’m just lost.
I don’t rlly care about the fuel and temp at the moment but I rlly would like the rpms to work.
I’m using a
arduino uno r3
BMW e36 VDO cluster
12v power
Jumper leads.
I have everything wired up as it should be (the tut I’m following) ie rpms is pin 20 on the x16 chip. I have power ect ect. But nothing. Ports are all set correctly in sim hub.
Is my 5v signal from my arduino not enough power ?????
Side note, the original video I watched
https://youtu.be/L59NL9EuEdM?is=tMx66QoqIw7-6uvx
Is out of date and does not work one bit.
I’ve sent a picture of the wire diagram I’ve followed