u/Ok_Supermarket9214 — reddlx

Round Dash Clock Upgrade

Im trying to get the interior buttoned up after making new seat covers. Since my factory clock is broken I've been inspired from others who have made something similar.

I'm still working out the kinks and screen arrangements. I plan to 3D print a low profile bezel and wrap it in matching vinyl. I wish they made a round screen a bit smaller in diameter so it would fit in the factory clock housing to maintain the look. Maybe as these become more common another size will be come available.

The screen size is actually good but ther is about a 1/2" band of unused surface that makes it too large.

Clock

Outside Temp

Inclinometer

Altimeter

Compass

Vehicle Voltage

GPS Speed.

Dims screen with headlight activation (all configurable by percentage)

I'll be adding a trip meter and possibly water and oil pressure down the road.

u/Ok_Supermarket9214 — 6 days ago

▲ 3 r/SuzukiSamurai

Cowl to HVAC plenum (under dashboard)

Im wanting to get some parts ordered for a Suzuki Samurai HVAC plenum that connects to the inside of the cab just below the cowl. Namely, seal/weatherstip/gasket, probably the neoprene variety.

I am away from home so cannot check but my new purchase ('87 TinTop) leaks somewhere behind the dash. Not tons of water but enough to warrant a whole dashboard removal so I can locate and correct the issue in addition to a good cleaning of all components and blower/heater core.

From pictures, it seems the plenum or manifold for the ducting fits into or over a flange beneath the cowl. Can anyone verify this and possibly recommend a size for the replacement of this gasket?

Thanks in advance,

reddit.com

u/Ok_Supermarket9214 — 3 months ago

▲ 1 r/AndroidQuestions

S26 Ultra has me locked out while abroad.

I'm in a bind with my S25 Ultra. It was purchased new and outright through Samsung's website (USA) maybe a year ago. I use Visible for cellular service.

I am in Brazil for work and I have my S25 Ultra on airplane mode and connected to wifi for general data use and messages via wifi calling as I am not paying up for international calling on my personal phone. My primary phone while in Brazil is my work phone, an S26 Ultra with international calling (AT&T).

My issue is that while at a hotel and connected to their wifi, my S25 Ultra asked for a PIN upon unlocking. I entered it as I often do (normally I use face recognition and finger print) and it said incorrect PIN, I re-entered it with the same result, eventually ending with an ever increasing lockout time (2-4-8-24 hours) between attempts. The PIN is correct.

I cannot get into my phone at all. It will not accept my pin. I have tried putting it in safe mode, powering off, on, rebooting. I have used smart things (web based) on my work phone to add another pin security barrier using a temporary pin but after entering it and it being accepted, I am dropped right back at the main unlock screen where my actual PIN is rejected and my timeout again increases (24 hours now). During the first power cycle it popped up an updating UI progress bar the finished but no improvement.

Oddly enough I had this happen once with my S26Ultra work phone upon entering Brazil. But after two failed attempts, I let the phone rest for about 20 minutes and it accepted my PIN on the third try and has worked well since.

I do not have much backed up to the cloud and none of my photos are. I do not want to factory reset because of the photos primarily.

Do I have any options to get this S25 Ultra unlocked?

Thank you in advance for the assistance.

reddit.com

u/Ok_Supermarket9214 — 4 months ago