u/Parking-Working1307

I know I can do the same checkmate without sacrificing my queen. I just didn't saw that before.

I am working on a modern hull design but I couldn't figure out how to make these rubber side panels. I saw some people make that on this channel. Also Is there a video that shows how to make it? Thanks in advance.

I was trying to get +600 ELO on blitz and this happend.

And it happened in a random bullet match lol.

My exams were finally ended. So, I just started designing again. Some of the composites on the gun mantlet isn't complated yet. Btw, each square is 150mm x 150mm this time. I tried to make the driver's comfort much better with low profile this time. Whole tank has a lower profile compared to the previous designs. Feedbacks welcome.

It said checkmate and I was happy at first but when I check again, I see that my time is over AFTER THAT CHECKMATE.

Each square is 150mm x 150mm on this one. Planning to put it on my last hull design. It has an 135 mm gun. Also, it has the Arena APS on both sides. E.S stands for Electronic Systems and C.P. stands for Control Panel. These rectangles on the front are ERA.

Each square is 200mm x 200mm. I made some changes on the driver compartment and the shape of the tank. Also the turret will be a bit backward compared to the previous one.